Rockler Piloted Flush Trim Router Bits - 1/4" Shank

The ball-bearing pilots on these bits make it virtually impossible to cut too deep, eliminating expensive and time-consuming rework. The bearing guide is on the bottom of the shaft, below the blades, which lets you trim face frames flush with cabinet sides, shelf caps flush with shelves, or veneers and laminates flush with the substrate. The cutter can also be used for template work where the template is below the worked material or, alternatively, with a router mounted in a router table where the template is above the worked material. In both cases it is suitable for straight and particularly shaped patterns.

• Two flute cutters
• 1/4" shanks

If a Rockler Router bit fails to perform for any reason we will replace it. No proof of purchase required. Exchange the product at your local Rockler retail store or mail it to Rockler at 4365 Willow Dr. Medina MN 55340. Name and address must be included in the package to process the exchange.

Tool Compatibility