Rockler Jig-It Cabinet Hardware Pro Drilling Guide

Updating cabinet hardware can quickly spruce up the look of a kitchen, bathroom vanity or piece of furniture. The hard part is drilling every hole for the mounting screws in the right place. This easy-to-use drilling guide helps you set the hole spacing and hardware position once, then repeat it across matching doors and drawers. For pulls, simply attach the actual pull you're installing to the guide to set the mounting post spacing. Position the guide, hold or clamp it in place and drill through the guide bushings with the included 3/16'' bit. You can also use it for single knobs and for two pulls on wide drawers.

Rockler Jig-It Cabinet Hardware Pro Drilling Guide Details:

• Install cabinet knobs and pulls straight, centered and consistently every time
• Simple to use: set the spacing of the mounting screws on the guide, position the guide on the door or drawer, drill the mounting screw holes and repeat!
 
• Uses the actual pull to set the hole spacing, so there is less measuring and chance for error
• Set the guide once and repeat the same placement across matching doors and drawers
• Works for single knobs and pulls up to 7-1/2" center to center
• Positions hardware from 1" to 8-1/4" from the edge of a door or drawer
• Indexing foot helps repeat the same side-to-side position on matching parts
• Indexing foot moves to either side for two-pull installations on wide drawers
• Interlocking racks prevent settings from shifting
• Includes a 3/16'' split-point drill bit with on-board storage and a hex key
• Optional Jig-It Knob and Pull Pro Drilling Guide Extension (#66762, sold separately) adds range for longer pulls up to 18'' wide
• Patent pending