Veritas Low-Angle Block Plane with PM-V11 Blade Kit

Here's a plane that's a delight to use. With its 12° bed angle, it excels at end-grain work. The tall side wings are ideal for shooting, and finger grips in the sides improve control. The combined blade advance and lateral adjust is the most sensitive, accurate adjustment mechanism available. Two guide screws prevent blade shifting. The ductile cast iron body can take hard knocks, and the adjustable nosepiece does not extend past the body, so it cannot be driven into the blade if you drop the plane. The plane is machined to exacting standards, and the milled sides and sole surface are ground to a fine finish. It includes a lapped 25° PM-V11 alloy blade. Made in Canada.

Veritas Low-Angle Block Plane with PM-V11 Blade Kit Details:

• Low 12° bed gives a cutting angle of 37° with the included 25° blade, excelling at end-grain work where higher-angle planes tend to tear
• Single adjustment mechanism controls both blade depth and lateral positioning simultaneously, described as the most sensitive and accurate available
• High wings sit at a machined 90° to the sole, making the plane well suited for use in a shooting board for trimming miters and end grain
• Recessed finger grips in each side of the body let you choke up on the plane for additional control in fine, precise work
• Adjustable nosepiece does not extend past the plane body, so it cannot be driven into the blade if the plane is dropped—a practical safety detail for bench use
• Dual guide screws hold the blade firmly during use, reducing the tendency for the blade to shift laterally under load
• PM-V11 is a powdered metal (PM) alloy that readily sharpens to a keen edge to cut cleanly and remain sharp for much longer than O1 or A2 tool steel blades