Rockler Router Bit Center/Depth Gauge

When setting up your router table or freehand router, there are two primary adjustments to make: the fence distance and the bit height. Our Center/Depth Gauge makes setting both easy and accurate. Just set the hairline indicator for the distance you need from the fence to the center of the bit, hook it onto the bit shank, then slide the fence over until it touches the gauge. To use it as a height gauge, simply set it at your bit height, lay the foot flat on the table and raise the bit until it touches the arm. Half-round notches let you register the gauge to the center of 1/4'' and 1/2'' shank router bits. Alternatively, you can use the ''depth'' portion to measure to the edge of the cutter, rather than the middle of the shank.

Features:

• Easily set your router table fence a precise distance from the center of your router bit—ideal for routing dados and flutes
• Also doubles as a height gauge for setting the heights of router bits and blades
• Half-round notches register to the center of 1/4'' and 1/2'' shanks
• Broad foot rests against router table fence, and is offset so the fence opening isn't a problem
• Hairline indicator adjusts for dead-on accuracy
• 12'' long steel ruler features metric and imperial measurements
• Nylon-tipped knurled knob secures gauge without marring ruler